This feeder will hold up to 40 lbs of feed. It has an internal funnel to ensure that all the feed is used. You mount it by suspending it by the handle. Its galvanized lid keeps water out and thus increases feeder life. Two hold-down chains keep the lid in place and provide for easy access. Comes with the Game Feeder I timer.

no.5624

Holds up to 100 lbs. of feed. Includes a funnel within the feeder to make sure all the feed is used. Includes a hanging chain and three mounting brackets. All mounting holes are prepunched and all mounting hardware is included. A galvanized lid keeps water out and lengthens feeder life. It is held in place by a spring on one side and a chain on the other, allowing easy access. If an overhead support is not available, nine foot by one inch legs are available. It is shown with the Game Feeder I timer but is also available with the Game Feeder II and III timers.

No.16624

This feeder is available in 100 (1"X 9'LEGS), 200 (1.5" X 9' LEGS) or 300 (1.5" X 9'legs) lb. sizes. The 100 and 200 lb. sizes may be suspended, but all may be mounted on legs. Heavy duty brackets permit either 1 or 1.5 inch legs to be used. A galvanized lid keeps out water and prolongs feeder life. It is held securely by a spring on one side and a chain on the other, which allows easy access. Use either the Game Feeder I, timers. Mounting hardware preinstalled.

100 w legs 16624L
200 lb w legs 30624L
300 w legs 55624L

This feeder contains: brackets, motor, 100 pound container, funnel, lid, wiring harness, control switch, and hardware. The feeder bolts onto either the bumper or receiver of your trailer hitch. A cable is provided that runs from the motor to the cab of your vehicle, where it plugs into the cigarette lighter. A switch controls when grain is scattered. A special patented rotor prevents grain from spilling when the motor is not turned on.


no tg-1